“Y’all boys are rough on equipment.” That’s what Mr. LaDuke said after my cousin Kent had broken three ax handles, a weed-eater and wrecked a moped. I guess we were pretty rough on equipment, that’s why half the every day tools and gear that we used in the hay field were broken to some degree. Pop was forever adjusting the square baler, which was always shearing pins, whatever that means. Most of the trailer jacks were bent. The old Ford truck had a tricky clutch that I never could get to cooperate. For every piece of faulty equipment, there would be a new oral operating manual that must be followed in order to get that particular item into proper working condition. These instructions were far from intuitive, and in some cases nothing close to the original manual, but I guess it was cheaper than replacement.
This rings true for every other place that I’ve worked over the past twenty years. The copier at one job requires you to jiggle drawer A before you can print. The computer at another place requires a restart before you can use the audio. The espresso machine at another place requires additional warm up time. There are always locks that require an odd key angle and a prayer. And vehicles that require you rev the engine to keep from overheating at a stoplight. I’m sure you’re thinking of a piece of equipment at work that you’d like to hit with a sledge hammer.
Probably the most dangerous faulty equipment that I have worked with were vehicles that required you to start them by bypassing the solenoid. I’m not dead certain what that even means, or why we had to do it, but basically, instead of cranking the engine with a key, like a normal person, you lay a screwdriver across the positive battery terminal and the negative terminal into the solenoid. This bypasses the solenoid relay switch and starts the car. Oh, and the key needs to be in the on positing in your ignition. 70% of the time it works 100% of the time.
This process is pretty simple on a lawnmower. Sometimes you see sparks fly off, but that’s part of the fun. If you have long arms and longer screwdriver, you don’t even have to get out of the seat of a zero turn to start it with this method. It’s a little bit trickier when you’re doing it on a truck. At one particular job, there was an old Ford Bronco that required this staring method. We were in downtown Winchester, VA getting a new lawn mower tire installed when my boss, Shawn, first showed me how to jump start the solenoid to start the truck.
I was so proud of myself when it fired right up and I got ready to back out into the street, with my lawn mowers on the trailer behind me. As soon as I put the Bronco in reverse, the engine stalled. I had to pop the hood, crawl out of the vehicle, and jump the solenoid with a pair of pliers. It fired right up this time. In reverse. The Bronco began backing out into the busy street. Panicking, I flung the pliers down and raced to catch the runaway vehicle. Fortunately I had left the door open and only had to run about twenty feet before I jumped into the moving vehicle. Once I got into the drivers seat and got the truck stopped I started breathing again. I was going to play it cool and just keep driving, but as I put the vehicle into gear I realized that the hood was still popped. I’m sure the people in the tire shop got a good laugh seeing me scramble so. I’d have laughed too. A couple of years later that Bronco burnt to the ground in a Wal Mart parking lot.
Equipment tends to wear out with normal use. But sometimes it gets help from clumsy employees, abuse and misuse. I can hear Mother’s everywhere saying, “This is why we can’t have nothing nice!”